Buick 2007 Rendezvous Bedienungsanleitung PDF herunterladen (Seite 255)

To scan preset stations, press and hold either

SEEK arrow for more than four seconds until

PSCAN and the preset number displays. You will

hear two beeps. The radio goes to the ﬁrst preset

station stored on the pushbuttons, plays for a few

seconds, then goes to the next preset station. Press

either SEEK arrow again to stop scanning presets.

The radio only seeks and scans stations with a

strong signal that are in the selected band.

Setting Preset Stations

Up to 30 stations (six FM1, six FM2, and six AM,

six XM1 and six XM2 (if equipped), can be

programmed on the six numbered pushbuttons, by

performing the following steps:

1. Turn the radio on.

2. Press BAND to select FM1, FM2, or AM, or

XM1 or XM2.

3. Tune in the desired station.

4. Press EQ to select the equalization.

5. Press and hold one of the six numbered

pushbuttons until you hear a beep. When

that numbered pushbutton is pressed,

the station that was set, returns and the

equalization that was selected is stored for

that pushbutton.

6. Repeat the steps for each pushbutton.

Setting the Tone

(Bass/Midrange/Treble)

AUDIO: Push and release this knob until BASS,

MID (midrange), or TREBLE displays. Then

turn the AUDIO knob to increase or to decrease

the tone. If a station is weak or has static,

decrease the treble.

To adjust bass, midrange, or treble to the middle

position, select BASS, MID, or TREBLE. Then

push and hold AUDIO for more than two seconds

until you hear a beep. BASS and a zero, MID

and a zero, or TREBLE and a zero displays.

255

1 2 ... 250 251 252 253 254 255 256 257 258 259 260 ... 527 528

Kommentare zu diesen Handbüchern

Keine Kommentare